QUESTION
NO: 1
Which
Cisco TelePresence C Series Codec command will move the on-screen display to
monitor output 4?
A.
configuration video osd output: 4
B.
xconfiguration video osd output: 4
C.
command video osd output: 4
D.
xcommand video osd output: 4
Answer:
B
QUESTION
NO: 2
Which
menu on the Cisco TelePresence VCS should you refer to in order to verify that
an
endpoint
has registered?
A.
Application
B.
Status
C.
Security
D.
Configuration
Answer:
B
QUESTION
NO: 3
After
you change the IP address of a Cisco TelePresence Codec C90, you are unable to
use Telnet or a browser to connect to that address. However, you are able to
use ping to connect to the new address. What are the two possible causes?
(Choose two.)
A.
The configuration failed and there is another device with the same address that
responds to the ping.
B.
The codec disabled the Telnet and HTTP services after the IP address change.
C.
The codec needs to reboot after the IP address change in order to bind the
services to the new address.
D.
The gatekeeper configuration failed and you need to set up the gatekeeper
address and the discovery type again.
Answer:
A,C
QUESTION
NO: 4
The
camera remote control is not responding. What can an engineer check in order to
determine if the camera remote control or the system is causing the problem?
A.
The monitor is on the right channel.
B.
The switch inside the remote control is switched on.
C.
The light flashes on the camera when a key is pressed.
D.
The batteries are correctly placed within the remote.
Answer:
C
QUESTION
NO: 5
Which
two items should you check on the local Cisco TelePresence C Series Codec when
audio is not received? (Choose two.)
A.
The microphone is plugged in.
B.
The microphone is turned on in the menus.
C.
The volume on the monitor is turned up.
D.
The far end is sending audio.
Answer:
C,D
0 Comments:
Post a Comment
Subscribe to Post Comments [Atom]
<< Home